InstallStrips, Trims & Fasteners — Everything for a Complete Panel Installation

This category covers the three things you need beyond the panels themselves: InstallStrips to fix panels to your wall with rated strength, trims to give the finished installation a professional edge, and fasteners suited to your specific wall type.

What's in This Category

INSTALLSTRIPS — Required for full-strength installation
Product	What it does	Use it when
InstallStrip — Standard Duty	900mm galvanised metal strip. Fixes to wall studs — panels hook onto claws. Breaks into 3 × 300mm sections.	Installing Standard Duty panels. 1 per 1.2m panel, 2 per 2.4m panel.
InstallStrip — Heavy Duty	1140mm galvanised metal strip. Same principle as SD but matched to HD panel groove height. Breaks into 3 × 380mm sections.	Installing Heavy Duty panels only. Do not use SD strips on HD panels — they won't grip. 1 per 1.2m panel.
TRIMS — Finishing products for a clean, professional result
Wide Trim (Corner Trim)	Wide L-shaped PVC trim that caps an exposed vertical panel edge. Fixed with Velcro or magnetic tape — no adhesive, removable. Colour options.	Covering the left or right exposed end of a panel run — where the panel edge faces outward and shows the internal structure.
Division Trim	Channel trim that snaps into the groove where two panels meet edge-to-edge. Hides the join line. Not compatible with InstallStrips at panel ends.	Covering the vertical join between adjacent panels. Clean, professional look with no visible seam.
FASTENERS — For fixing InstallStrips or panels directly to your wall
Screws 7g×40mm (100pc)	For fixing Installstrips to plasterboard or similar surface.	Timber studs are the main wall structure.
Colour-matched screws 7g×40mm (50pc)	Screws colour-matched to panel finish. For fixing panels directly through the face into timber studs without InstallStrips.	Face-screw installation only. Note: weight capacity drops ~75% vs InstallStrip installation.
Mushroom Nail Anchors 5mm×40mm (100pc)	Nylon nail-in anchors for fixing InstallStrips to brick or concrete. Hammer-install into pre-drilled masonry holes.	Brick and concrete walls. Minimum 10 anchors per InstallStrip recommended.
Mushroom Nail Anchors 6.5mm×50mm (100pc)	Larger masonry anchors for plaster over brick wall. Deeper bite to reach into brick.	When plaster is installed directly over brick or masonry wall. 50mm provides a deeper reach.
45mm Plasterboard Anchor (each)	Zinc/nylon screw-in anchor for plasterboard between studs. Rated to 10kg per anchor.	Adding supplementary InstallStrips where no stud is available. Not for primary panel support.
Red Wall Plug 6mm×50mm 10g (25pc)	Standard masonry wall plug for concrete or brick. Used with appropriate masonry screws.	Alternative masonry fixing where nail anchors are not preferred.
Magnetic Tape Strips 10cm (each)	Self-adhesive magnetic tape for attaching Wide Trim to panel edges. Removable and repositionable.	Fixing Wide Corner Trims without adhesive. Allows trim to be removed if layout changes.

InstallStrips — Why They Matter More Than the Panels

InstallStrips are what give StoreWALL panels their rated weight capacity. Without them, all accessory weight ratings — hooks, shelves, baskets — drop by approximately 75%. The panels sit clean against the wall with no visible fixings, all load is distributed across the galvanised steel strip rather than concentrated at individual screws, and panels can be removed and rehung at any time without leaving holes.

Order the correct type: Standard Duty InstallStrips for SD panels, Heavy Duty for HD panels. They are not interchangeable — the claw dimensions are different.